Allows Third Hand Opperation

Not To Scale

The Pro Mag Weighs 1.5 Lbs. Is 9 in. Long, 2 in. in Height
It is 3/4 in. Thick and is Made from Cast Aluminum

The Industrial Frame, the Powerful Magnets,
And the Large 1 3/4 inch Protractor Vial
Make This an Indispensable Tool for Bending Large Conduit.

I Have Picked up a Full Joint of 3" EMT with This Level

The Preferred Level by Seasoned Journeymen, for many Years.

If You like to Bend to the Bubble, This is Your Baby for Big Pipe

A Heavyweight Easy to Use Tool for Determining Angles,
the Pro-Mag level has Two Cast In 25-Pound Pull Magnets that hold securely to any steel surface.

The unit has a 360-degree Adjustable DSL
With Two 90-degree quadrants Graduated in 2-1/2-degree increments.

Also cast in are tables used to convert degree-of-angle to
rise-in-inches-per-foot or millimeters per meter.
A groove on the bottom edge permits use on a small pipe.

STOP BENDING SCRAP

You can Resolve this Protractor to 1/2 degree
By Eyesight

Unfortunately No Longer Made in the USA
I am still going to make these available on my web site
as there is no substitute Made in America
I was paying $65 US Retail for these in 1980
These are from China

$67.50 + S&H This Item $6.99

CA Residents Add 8.25%

Hey That's Not on The Tool List Brother

So Tell Your Boss to Get this Item for You

What Does a Stick of 4" Conduit Cost These Days?

Actually, I just looked it up and Rigid is $127.50
FOB (Without Delivery Cost)
EMT was $55.34 a Joint on 5/17/07

The Build Up Rate for a JW in CA is $75 An Hour

Hmmm ---- How much Scrap is Too Much Scrap